I've never had a problem playing RTSP streams under Linux (Mint), but it may vary with the specific codec in use in the stream.
I am always a bit suspicious about attached executables, but your file has been pronounced as safe by VirusTotal.
Yes, if you wish to avoid the possibility of the entire internet being able to access devices on the LAN the router is connected to.
This is because, when UPnP is enabled on the router, it gives a device on the LAN that also has UPnP enabled the ability to automatically create a port-forwarding...
Let us know if you manage to get the auth working and extract a flash dump - it's not too hard to unpack it, and with any luck the way the config is held has not changed with firmware updates.
If still needed ... late response.
Not a total flash dump - but you should be able to stitch all the partitions together.
These were taken after the bootloader cfgRestore command.
I expect you know the default web admin passwords.
And you might need this :
root:ab8nBoH3mb8.g:0:0::/root:/bin/sh...
I'd hoped they hadn't, but I'm not surprised, that Hikvision have progressively locked down some of the ways that have been used / discovered to mess with the device internals.
Long shot - optimistic - try this without 'debug'. It's not important, it (used to) just provide extra detail in the...
A year or so back, I was sent a faulty one of these (unsolicited) by an eBay seller wondering if I could fix it up.
I found that a downstream power converter had been damaged by water ingress.
I worked around that and got it to boot, but it wasn't in a state to sell on.
But out of curiosity, as...
Well done!
If they are not China region cameras with hacked firmware - then the normal upgrades should work OK.
A clue may be in the serial numbers - CCCH usually indicates Chinese.
With the caveat that I have no specific knowledge of that (unspecified) NVR, but I've tinkered with a few different models -
Check if under the Events configuration there is a list of exceptions (other than things such as motion events etc) for which alarms such as the beep can be enabled or...
I'm guessing this model may be a 'Value Series' one, without smart features.
I think you are correct. That's a pity.
And the camera appears to be using the latest firmware, E10 series.
Just a thought - do you have this menu? If VCA resource is set to Monitoring, there are no Smart Events.
It's a normal part of the camera settings, but availability may depend on the firmware version.
What firmware version does your camera have?
Example on a similar, though not identical, camera model :